Page 4 of 4

Re: nRF24LE1 + MCU

PostPosted: Fri Jun 01, 2012 8:20 am
by fintor
If you're using a chip antenna, then you have to put it at the end of the board, because (at least with most chip antennas) you typically don't want to run a ground plane under it or past it.


So it should be okay to put it in one corner, as long as there is no ground plane running under it or past it?

Thanks for all the replies. It has been of immense help :)

Re: nRF24LE1 + MCU

PostPosted: Fri Jun 01, 2012 12:23 pm
by brennen
fintor wrote:So it should be okay to put it in one corner, as long as there is no ground plane running under it or past it?

That should work out just fine. Do consult the datasheet for your particular chip antenna to find out if it's one of the rare ones that actually needs a ground plane under it or other special components before you do the layout, though. :ugeek:

Re: nRF24LE1 + MCU

PostPosted: Wed Apr 06, 2016 9:02 am
by AyushJain
I have also purchased NRF24le1 and was struck using that . Luckily i found all the details at this blog http://techshlok.com/blog/introduction-with-nrf24le1/
You can find code of so many projects using NRF