Page 1 of 1

protocol of wireless sensor network with nRF24LE1

PostPosted: Fri May 23, 2014 2:37 pm
by Haox
I use nRF24LE1 to create a low power, real time wireless sensor network. It means that datas are converted by the integrated ADC and then sent by nRF24LE1 continuously. The delay must be as small as possible, because it is a real time system.
There are 9 sensors in my system, so should I use two nRF24LE1 chips as the receivers ?
Does anyone know a suitable protocol for my system? Gazell is an option, but I am an absolute fresh man of nRF24LE1, can anyone give me some advices?
Thanks!

Best regards,

Haox

Re: protocol of wireless sensor network with nRF24LE1

PostPosted: Wed May 28, 2014 12:11 pm
by brennen
So is each of the 9 sensors going to be an nRF24LE1 node? Do all of them need to be able to transmit constantly, or can they transmit one at a time? Does only one master node need to hear all of the sensors, or do they need to communicate with each other? Where is the data ultimately going that gets sent over the network?