what to use to program nrf42le1

Questions for programming 8051 microcontrollers in C or assembly using SDCC

what to use to program nrf42le1

Postby joselalupa » Sat Sep 06, 2014 4:24 pm

i am pretty confused on how or what do i use to upload a program to this sensor, i've seen mPro programmer but it has a 10 pins connector but the sensor has other layout in the pins...anyone could clarify this?
joselalupa
 
Posts: 32
Joined: Tue Aug 12, 2014 4:44 pm

Re: what to use to program nrf42le1

Postby brennen » Mon Sep 08, 2014 12:21 pm

If you have one of our devices, you just need to connect a serial adapter to the RXD, TXD, and RESET pins on the nRF24LE1 (there are several posts on here describing in more detail how to connect the pins). If you have a raw chip, then you'll have to find a hardware programmer. I have code that allows an nRF24LE1 to program another nRF24LE1 over the hardware SPI interface, but you have to be able to program one of the nRF24LE1's to be the programmer.
brennen
Site Admin
 
Posts: 395
Joined: Sun Aug 17, 2008 2:15 pm

Re: what to use to program nrf42le1

Postby joselalupa » Mon Sep 08, 2014 6:38 pm

i've tried to buy the transceiver and programmer from your site but it says sold out, everything. is it still open?
i had to buy this from ebay but i am all confused, the information i've found doesn't look to correspond to the same transceiver

http://www.ebay.com/itm/130951124790?_trksid=p2059210.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
joselalupa
 
Posts: 32
Joined: Tue Aug 12, 2014 4:44 pm

Re: what to use to program nrf42le1

Postby brennen » Tue Sep 09, 2014 8:19 pm

For all intents and purposes, I've stopped making boards for the foreseeable future. I don't know much about that board you linked to, though.
brennen
Site Admin
 
Posts: 395
Joined: Sun Aug 17, 2008 2:15 pm


Return to 8051 Programming

Who is online

Users browsing this forum: No registered users and 1 guest

cron