getting errors in eclipse

Questions for programming 8051 microcontrollers in C or assembly using SDCC

Re: getting errors in eclipse

Postby joselalupa » Tue Dec 22, 2015 12:08 am

Do you have any programmer or developing board i could so you can efectively help me? You story is closed
joselalupa
 
Posts: 32
Joined: Tue Aug 12, 2014 4:44 pm

Re: getting errors in eclipse

Postby brennen » Tue Dec 22, 2015 3:13 pm

My store is still open. I just haven't really done much with it in the last while. I would suggest getting one of the LE1 development boards and one of the FT232R bootloader programmers.
brennen
Site Admin
 
Posts: 395
Joined: Sun Aug 17, 2008 2:15 pm

Re: getting errors in eclipse

Postby joselalupa » Tue Dec 22, 2015 6:23 pm

i'll follow your recommendations, i found the ft232r but cannot findthe le1 programmer on your site, could you point me the url? in that board could i connect my sensor? (nrf24le1). i have the pins identified. i am working on a personal project
joselalupa
 
Posts: 32
Joined: Tue Aug 12, 2014 4:44 pm

Re: getting errors in eclipse

Postby brennen » Tue Dec 22, 2015 7:52 pm

You can get one of my LE1 boards and use it as a hardware programmer. I have code linked on the product page to allow you to do it (you would use my bootloader programmer to program my LE1 as a hardware programmer). The bootloader programmer requires my bootloader to be in the flash memory of your LE1. All of my boards come with the bootloader pre-programmed in flash memory, but I doubt yours already has it.
brennen
Site Admin
 
Posts: 395
Joined: Sun Aug 17, 2008 2:15 pm

Re: getting errors in eclipse

Postby joselalupa » Wed Dec 23, 2015 2:17 am

As i can understand i can connect my sensor to your board to program it, right? Could you give me the links to buy what you recommend?
joselalupa
 
Posts: 32
Joined: Tue Aug 12, 2014 4:44 pm

Re: getting errors in eclipse

Postby brennen » Wed Dec 23, 2015 5:47 pm

I'd recommend the 24-pin chip antenna board (http://store.diyembedded.com/index.php? ... ucts_id=12) and the FT232R bootloader programmer(http://store.diyembedded.com/index.php? ... ucts_id=36). You'll connect the bootloader programmer to my LE1 board so you can communicate to the my LE1 board over serial with your computer. You can then use the serial programmer application for your PC to program my LE1 board with the code that allows my LE1 board to program another LE1 board. You'll then use the serial terminal to send the hex file to my LE1 board, which will program your board.
brennen
Site Admin
 
Posts: 395
Joined: Sun Aug 17, 2008 2:15 pm

Re: getting errors in eclipse

Postby joselalupa » Wed Dec 23, 2015 11:31 pm

great, your explanation sounds long but not complicated. after all christmas hollidays i'll buy the items to finish the projects, i really appreciate your help
joselalupa
 
Posts: 32
Joined: Tue Aug 12, 2014 4:44 pm

Previous

Return to 8051 Programming

Who is online

Users browsing this forum: No registered users and 1 guest

cron